Membrane Switch Method Steps


Release time:

2023-12-29

Membrane Switch Method Steps

Method steps

1. Clean the surface to be attached to the membrane switch (the surface to be attached is required to be flat, free of rust, oil and dust);

2. Compare the size (put the membrane switch in the place to be pasted to compare whether the size position is right); [4]

3. Peel the centrifugal paper at the bottom of the membrane switch about 10mm from the side;

4. Then put the membrane switch in the corresponding position and stick it to a part, then slowly tear off the remaining centrifugal paper (in the case of an angle of no more than 15 degrees), and then stick it to the corresponding position in turn. [4]

5. In the process of pasting, if the membrane switch of the reverse centrifugal paper needs to be placed first, the reverse side should be placed upward to prevent sticking to other objects and affect pasting;

6. Precautions: Paste cannot be repeated and must be completed at one time. The tearing angle cannot exceed 15 degrees; When trying to press the hand feeling, be sure to lay it flat on the desktop and press it again. You cannot hold it in your hand and press it, otherwise it will affect the service life of the membrane switch.

Keywords: membrane switch, membrane panel, touch screen